xNecessityx
Cadet
- Joined
- May 31, 2018
- Messages
- 11
I’ve had two of these motors. Never seen more than 102 even when fresh.
Looks like you found the bad hole. Was that the plug I pointed out earlier?
Best case scenario is a blown head gasket. Pull the head to take a look
Okay that’s good to know, about the 100 psi, not so much the 50 haha. I’m not very competent when it comes to pulling the head but I’ll watch some videos and see. Is it relatively difficult to do? Also, would this be causing the rough running engine and loss of WOT power?