Hi.
is there any tool to remove cam puley from valve shaft. This cam puley is made in black plastic.
i dont want to brake it or brak cast iron valve shaft.
any tips?
well,it stack very hard. i put under the puley 2 flat screv drier and tap into shaft. the end of story was broken top of cam shaft
on top of the puley are 2 holes. i think its for puler.
the right puler is 3AC-99736-0 +3AC-99737-0
On an MFS8/9.8?
If there are 2 threaded holes, yes, you can use a harmonic balancer puller.
So now you need a new cam as well. Ugh.
No mention of a puller in the Factory service manual for the MFS9.8A3...