My engine has been starting perfectly.
This part is new..... No beep and no lights on tach when switch is activated. Engine will turn over easily but doesn't fire. Something else new.. Trim switch on engine works both ways. Trim on binnacle goes up doesn't go down. Checked switch on binnacle for continuity no issues.. Also high pressure fuel feed pump was not coming on when the key is turned on. Pulled it works when powered. Since tach doesn't work I can't self diagnose. Checked electrical connections on harness and they all seem good. It does seem like an electrical connection issue but I just don't get what could have happened sitting in my driveway. Better here than on water. Dealer no where close. Any ideas? ECM?
This part is new..... No beep and no lights on tach when switch is activated. Engine will turn over easily but doesn't fire. Something else new.. Trim switch on engine works both ways. Trim on binnacle goes up doesn't go down. Checked switch on binnacle for continuity no issues.. Also high pressure fuel feed pump was not coming on when the key is turned on. Pulled it works when powered. Since tach doesn't work I can't self diagnose. Checked electrical connections on harness and they all seem good. It does seem like an electrical connection issue but I just don't get what could have happened sitting in my driveway. Better here than on water. Dealer no where close. Any ideas? ECM?