So I'm swapping powerheads on my 1988 Force 125 to make it a 150.
I had to replace the lower motor mount. Not too bad.
I've got my hillbilly engineering hat on, so forgive me if this is a stupid question:
The old motor mount components were all intact, including the rubber cushion. Looks to me like they were just glued at the factory.
Can I just clean those plates and the rubber cushion and glue them back together? The polyurethane glues hold like a vise in my experience.
I had to replace the lower motor mount. Not too bad.
I've got my hillbilly engineering hat on, so forgive me if this is a stupid question:
The old motor mount components were all intact, including the rubber cushion. Looks to me like they were just glued at the factory.
Can I just clean those plates and the rubber cushion and glue them back together? The polyurethane glues hold like a vise in my experience.