wewefirex2x
Petty Officer 1st Class
- Joined
- Feb 19, 2007
- Messages
- 267
I purchased a new blue sea m-series dual battery switch. I marked all connections on the perko switch i removed. I am kinda stumped and will try to make sense of the question I am going to ask.
The #1 terminal should be for the starting battery
The #2 terminal should be for the deep cylce battery
common should be for any hot while ingnition is on
This is how much old switch was wired...
I am assuming the #2 terminal was wired to the starting battery
I am assuming the #1 terminal was wired to the deep cycle battery
I am curious if I take the starting battery and make it terminal #1
and take the wire on the deep cycle battery and make it terminal #2 would I be fine? What else should I trace?
Right now I have 3 wires going to common, 1 supposed to go to terminal #1 and 1 wire going to terminal #2.
I was starting to get really frustrated and had to walk away.
The #1 terminal should be for the starting battery
The #2 terminal should be for the deep cylce battery
common should be for any hot while ingnition is on
This is how much old switch was wired...
I am assuming the #2 terminal was wired to the starting battery
I am assuming the #1 terminal was wired to the deep cycle battery
I am curious if I take the starting battery and make it terminal #1
and take the wire on the deep cycle battery and make it terminal #2 would I be fine? What else should I trace?
Right now I have 3 wires going to common, 1 supposed to go to terminal #1 and 1 wire going to terminal #2.
I was starting to get really frustrated and had to walk away.