BigBand
Cadet
- Joined
- Jun 2, 2002
- Messages
- 17
I need to do a rather odd install on a Lowrance HDS Gen3 fish finder/GPS.
Both transducers (standard and skimmer) obviously will be on the transom, but their cables need to go to connectors on the transom, about three feet away. I know I need waterproof connectors for these, but what I don't know is how many conductors in each cable, and are any of them coax?
The main run of wire will then snake through the inner structure of the boat, and will emerge up near the bow, where they will also need the same connectors again. Then up to the display about three feet or so. There will also be the power cable at the bow, a third connector.
1. Can anyone shed some light on these questions?
2. Also, any recommendations on the connectors?
Both transducers (standard and skimmer) obviously will be on the transom, but their cables need to go to connectors on the transom, about three feet away. I know I need waterproof connectors for these, but what I don't know is how many conductors in each cable, and are any of them coax?
The main run of wire will then snake through the inner structure of the boat, and will emerge up near the bow, where they will also need the same connectors again. Then up to the display about three feet or so. There will also be the power cable at the bow, a third connector.
1. Can anyone shed some light on these questions?
2. Also, any recommendations on the connectors?