64osby
Admiral
- Joined
- Jul 28, 2009
- Messages
- 6,799
I was able to trade my 12' Sea King tinny for this 1963 14' Big Fisherman Lone Star.It has a couple issues that I'm looking for advice on how to repair.#1 the corner cap has a wear gouge in it. It looks like it's still structurally ok, so far. It has a pretty sharp edge and I want to clean it up. Options I've consideredA - cap it with some sheet aluminum B -look at having weldedC - JB WeldD - replacement cap?#2 - The rail has a couple chunks taken out of it and a partial crack, Options I've consideredE - form a cap out maybe 18" long of some thick extruded material and fasten it F - cut out the damaged horizontal portion and have a matching a piece welded inG - other suggestions?#3 - At one point I believe there were handles between the seat support brackets above the seat. There are two holes. Does anyone have information about or pictures of the handles? I would like to install some, they don't need to be a match to the originals but I would like to know what they had to begin with.H - I have some 1/2" round Alum thick wall tube stock that could be tapped on both sides and bolted in place. It could also be bent to form an arc which might make it easier to grip if needed.Leak test will come soon, hopefully it will be ok, the PO stated it did not leak.Paint next year, rustoleum w/ hardener most likely.Any input is welcome.
Edit 2-10-12 Link to photobucket pictures
http://s1158.photobucket.com/albums/p605/62iia/Lone Star 14 Big Fisherman 1963/
Edit 2-10-12 Link to photobucket pictures
http://s1158.photobucket.com/albums/p605/62iia/Lone Star 14 Big Fisherman 1963/
Last edited: