Hi. I’ve been reading a lot and watching a lot of videos on fiberglass repair, because I might be doing some. I’ve never done it before, so I’m gonna practice on an old boat that I had no intention of ever using. There are some clean drill holes in the practice boat. Would I need to sand those down so that the hole is more tapered down, or could I just go straight ever a hole like that? If I need to taper it down, how far should I go.
Same me question for a circular saw cut. Go straight over, or taper it down?
thanks
Same me question for a circular saw cut. Go straight over, or taper it down?
thanks