Another update from AMSTERDAM:
-Removed the middle stringer
-glassed in the 2 side stingers with 1x csm 450gram + 1x 435gram
-glassed in the 2 middle side stringers with 1x csm 450gram + 2x 435gram
Glassed in the middle/center of the hull touching the 2 middle side stringers with 2x csm 450gram (U-profile)
On schedule tomorrow:
-center stringer placing with putty, glassing 1x cms 1x biax
-other hull patching+glassing:
Upcoming problems:
-stringers placed to high, they height of the stringers matches exactly the top of the old floor. (Any solutions / tips)?
-The sides of the top cap and lower part has a lot of holes near the edges looks like a cheese hole cap( Any solutions / tips fixing these)?
-Paint job, any suggestions what to do? As I can’t figure out if it’s bad?
Enjoy!