thank u again
few ??
i redid the stringers as original
i glued down new floor as original with the mixing fibers and poly resin
as u could see on the pictures the new floor has round curve
the white round spot on the transom is the drain
should i seal the new floor from the boat bottom hull ? and install separate inspection plate in the floor just in case of bilge pump out ?
right now as i can see is :
seal the new floor with boat hull bottom completely
install bilge pomp in that place
to remove water from the deck
make new opening for the another bilge pump between deck and hull Thank u
i hope that u could understand what im asking
)