I've been debating the best way to work on this boat. I know I need a new transom and the floors are looking rough in spots so i was going to remove all of it. I was looking for the best way to do this. Does anyone know if you can take to top blue part off. To me it looks like the steel trim that is riveted on holds it in place. Can i cut all the rivets and pull the trim then pull the inside blue part out or is that fiberglassed in. Also if i can get that off where are the best places to cut the floor boards out so that i can easily put new ones in. One more question, What is the best way to get the transom unglued from the outside fiberglass. From what i read i should be able to get that out and cut a new piece and re-glue it to the exterior fiberglass. Thanks in advance.