Deerhunterguy22
Cadet
- Joined
- Aug 27, 2017
- Messages
- 9
I have been lurking for years and always seem to find what I need without subscribing. I need help with this one as I can't find exactly what I need. I am replacing my transom due to splashwell drain rot and planning to go at it from the inside. The questions I have are where to cut everything out to make this as painless as possible. Should I start hacking away and cut out all of the foam and go from there? Another thing I haven't seen before is the horizontal board laying horizontal under the splashwell that goes full width. The last thing I noticed when digging out the transom from the top is it is doubled up ply til about 8 inches down and a single ply glassed in from there to the bottom. Thanks in advance to all.