Yamaha gas guage problem

[Gep]

I have a 1992 Yamaha 130hp TXRQ engine,a 62 gallon Rayco Manufacturing gas tank, and a LCD Marine meter.I cannot figure how to hook back up the gas guage after I had to take the console off and take the wiring apart.I have a pink wire with a male bullet connector, and a black wire with a female bullet connector coming off of the gas tank.Here's what I have left as far as wiring to hook into to on the LCD marine meter:1-black wire with female bullet connector,1-blue wire with female bullet connectorThese are bundled together by themselves.I also have:1-white wire with female bullet connector,1-white wire with a blue stripe with a female bullet connector.These are what are left from the other bundle of wires.I am totally confused! Can anybody help?Thanks,Mike

[JB]

Ahoy, Mike.I jumped to my bookcase to check the yammymanual, then realized I gave it to you with the boat/engine. That is the only place I would think to look.Good luck.

[Gep]

Hi JB,I've scoured the book.The wiring schematics page is so small that I had to make a copy of it and enlarge it by two hundred percent and even still it's hard to read with out a magnifying glass or a loop.It shows how to wire everything except the Marine meter. It only shows the tach.I already have that working.I think I have some wires that I already hooked up that are wrong, so I'm probably not only dealing with the wires I have left but probably some others also.I just this weekend figured out how to hook back up the volt meter and hour timer.One of these days I'll send you some photos of the restoration.Mike