gusthewonderslug
Petty Officer 3rd Class
- Joined
- Jun 25, 2013
- Messages
- 79
Hi all I have put the carby back onto my 1968 Lark 40 motor after cleaning it out and replacing the needle and seat, clean jets, new fibre washer on emulsion tube and I now have no fuel getting to the bowl.
My only thought is that I,ve installed the float upside down is there anything else I could have done to cause this?
I will pull the carb off tomorrow to see what i've done wrong but any suggestions are appreciated.
Gus
My only thought is that I,ve installed the float upside down is there anything else I could have done to cause this?
I will pull the carb off tomorrow to see what i've done wrong but any suggestions are appreciated.
Gus