skinnerno1
Recruit
- Joined
- Jul 28, 2013
- Messages
- 1
hi. I have a 1982 mercruiser 120. I replaced the rear motor mounts, gimble bearing, drive shaft and engine coupler. I am trying to align the motor with the alignment tool and I see that the motor is to the port side about 1/8th inch (off center 1/16th). I don't know what to do to shift it over. I tried to loosen all the mounts and use a pry bar to get it to move a little but it wont. has anyone here ever ran into this problem? I am new to the boating world and would sure appreciate any help that would get me on the water. thank you very much.
0
0