BOLT found in bilge - need help identifying please

F

Froeman

Cadet
Joined
Sep 17, 2012
Messages
22
I have a 2008 Larson 180 with a 3.0L Volvo Penta (GL?) motor. SX outdrive. There are 53 hours on the boat. I found this bolt lying in my bilge a few days ago. I only had time for a quick visual inspection, but I can't see any obvious places where a bolt is missing. The boat runs fine (as far as I can tell).

The bolt is 2.5" long.

CAN SOMEONE PLEASE HELP guide me where to check?

Thanks!
 

Attachments

  • bolt.jpg
    bolt.jpg
    96 KB · Views: 0
G

Glastron3.0GLP-C

Seaman
Joined
Oct 21, 2012
Messages
61
Re: BOLT found in bilge - need help identifying please

Looks like the 3812255 Flange Screw from the circulating pump pulley.
 
Don S

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: BOLT found in bilge - need help identifying please

What is the diameter of the bolt?
 
F

Froeman

Cadet
Joined
Sep 17, 2012
Messages
22
Re: BOLT found in bilge - need help identifying please

Glastron3.0GLP-C said:
Looks like the 3812255 Flange Screw from the circulating pump pulley.
Click to expand...

Agree it looks a LOT like those screws, however, all 4 of them are present in the motor... are these used anywhere else in the motor?
 
A

aerobat

Master Chief Petty Officer
Joined
Jun 1, 2011
Messages
835
Re: BOLT found in bilge - need help identifying please

i think you will find these bolts in many places around the pulleys of the alternator, circulating pump and the according mounting brackets - i would look here carefully . i do not think such bolts are used in the alterntor or flywheelcover area .

it might also be the previous owner changed a part and used new bolts and now you found an old one in the bilge.

not an easy question where exactly this bolt is from .
 
F

Froeman

Cadet
Joined
Sep 17, 2012
Messages
22
Re: BOLT found in bilge - need help identifying please

Thanks everyone... the main thing I'm worried about is that the bolt fell out of the motor block somewhere and it is a key piece of holding everything together. Wouldnt' want a catastrophic failure out on the water. I'll re-check the pulleys etc. and try to snap a photo or two to post.
 
F

Froeman

Cadet
Joined
Sep 17, 2012
Messages
22
Re: BOLT found in bilge - need help identifying please

I think I found it. Seems to be part of the pully bracket assembly.. found another piece laying on the ground as well. See photo. Agreed? Thank you all again.
 

Attachments

  • bolt2.jpg
    bolt2.jpg
    98.9 KB · Views: 0
Don S

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: BOLT found in bilge - need help identifying please

Is that the spacer (in your hand lower left of photo) that goes in that gap?
 
F

Froeman

Cadet
Joined
Sep 17, 2012
Messages
22
Re: BOLT found in bilge - need help identifying please

Don S said:
Is that the spacer (in your hand lower left of photo) that goes in that gap?
Click to expand...

Yes Don, I dug up an old photo of the motor and that bolt & spacer are there. MYSTERY SOLVED! THANKS EVERYONE!!
 
You must log in or register to reply here.
Top