Sevenscrew
Seaman
- Joined
- Apr 21, 2013
- Messages
- 57
I hit the outside race of my gimbal bearing in my alpha one gen 2 with a punch a few times (5)? To make sure it wasn't crooked. And it scuffed up the surface. But could this have ruined the gimbal bearing? At first when I spun it after greasing it it felt like one spot in the revolution was hard. But this was just after greasing it (without spinning it while greasing it) so maybe the spot was the grease ? But now it spins tight and evenly .
Also, the two halves of the grommet for my wires, one half is noticeably out further then the other but the retaining clamp is tightened down. Is this normal?
Also, the two halves of the grommet for my wires, one half is noticeably out further then the other but the retaining clamp is tightened down. Is this normal?