Hi all,
I just changed the anodes on my MC1 and during replacement the 2 bolts securing the anode to the trim splitter on the base of the out drive by the transom sheered.
I removed the hydraulic pipes to remove the diverter valve so I could drill and retap to M8. This was successful but do I now need to bleed the system and if so is there any advise about the operation that would come in useful ?
Many thanks
Ron.
I just changed the anodes on my MC1 and during replacement the 2 bolts securing the anode to the trim splitter on the base of the out drive by the transom sheered.
I removed the hydraulic pipes to remove the diverter valve so I could drill and retap to M8. This was successful but do I now need to bleed the system and if so is there any advise about the operation that would come in useful ?
Many thanks
Ron.