Quicksilver classic 3000 replacement or repair part help needed

Alanvan69

Cadet
Joined
Jun 5, 2011
Messages
15
Hello I have determined that the inside of my throttle control box is badly gouged and in this part is a a bearing that is now stuck in its so gouged up. The forwards/backwards works fine but there is no throttle advance. I need to find a replacement for this part. For those that may know its the two parts put together after u remove the snap ring. I think what is suppossed to happen is that these two parts are suppossed to turn seperatly if u push the throttle only button in to advance the throttle to get gas to the carbs or together if ur actually shifting and throttling up. I am not sure what u call that part as its the internal shift parts but its bad ( like 1/8" gouged bad ) and all else cables etc on boat is good. Motor and controller is for a 98 merc 60hp ELPTO. So I need to upgrade to a new shifter or find this part.

Thanks Alan
 
Top