hi guys, just joined the club and hope to have some good times here
well, I just picked up a 48 zephyr, hadn't been run in some time, so I went through some basics before trying to start her up
I am new to this type of vintage and have no clue as to the starting procedure and settings let alone the basic settings for the engine
I set the had throttle in the start position, the central black knob to cold start and the magneto lever in the central position
I primed and checked to make sure I had fuel in the float, and I did, got a small firing after a few tries, but after that nothing
I have no idea where the low circuit needle needs to be or for that matter anything else..
please help!
well, I just picked up a 48 zephyr, hadn't been run in some time, so I went through some basics before trying to start her up
I am new to this type of vintage and have no clue as to the starting procedure and settings let alone the basic settings for the engine
I set the had throttle in the start position, the central black knob to cold start and the magneto lever in the central position
I primed and checked to make sure I had fuel in the float, and I did, got a small firing after a few tries, but after that nothing
I have no idea where the low circuit needle needs to be or for that matter anything else..
please help!