Removing the shift linkage bellcrank bar on a VP SX-M

K

kelleyja

Seaman
Joined
Feb 9, 2011
Messages
62
Hello all, hoping someone can help me with this.

I have a Penta SX-M drive on a 4.3GSPLKD, and I am trying to change the drive rotation by reversing the shift linkage on bellcrank per the instructions in the Volvo service manual.

The manual says to remove the cotter pin on the bellcrank while holding the slotted end with a screwdriver, which I did. Now I cannot get the bar to budge, it doesn't look like its threaded, is it just press fit into the drive housing?

Any tips on how to remove it? :confused:

Bellbar.jpg
 
Don S

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Removing the shift linkage bellcrank bar on a VP SX-M

Should just push out after you remove the cotter pin. Corrosion may be holding it.
 
K

kelleyja

Seaman
Joined
Feb 9, 2011
Messages
62
Re: Removing the shift linkage bellcrank bar on a VP SX-M

Thanks Don, I didn't want to use too much persuasion in case there was something else holding it in there. I will hit it with some penetrating oil / heat and try it again
 
You must log in or register to reply here.
Top