was wondering if any body ever tried getting dents out off the pontoons mine look like somone set it down on some blocks and the end of both pontoons dented in from the weight of the boat there is a place to hook a air line to them thought about putting pressure to them but was scared it might blow out the welds any ideals
I think the air chucks you are talking about are for blowing water out of pontoons i don't think i would try to pressurize them but then what do i know best bet would be to get ahold of the mfg. and ask them about it.
If the dents do not have severe distortion like hard bends etc but rather just a depression you should be able to pull them with a automotive dent puller with a suction cup. I would also refrain from presurizing them.
dented pontoon
Linear Mode
