txbandit44
Petty Officer 2nd Class
- Joined
- May 11, 2008
- Messages
- 182
OK few quesitons here
One of the carb bases has a jet stuck in it. Stuck so bad that i broke my brand new OMC jet tool.
Good news is it looks like the jet is clean and I could just put this all back to gether and run it. But I have a problem with not doing it right.
so to the questions
Can you still get the float chamber assy? Not the middle carb with the fuel inlet.
Are all of the orifaces in the float chambers the same? The other 2 carbs have .54d stamped on them.
One of the carb bases has a jet stuck in it. Stuck so bad that i broke my brand new OMC jet tool.
Good news is it looks like the jet is clean and I could just put this all back to gether and run it. But I have a problem with not doing it right.
so to the questions
Can you still get the float chamber assy? Not the middle carb with the fuel inlet.
Are all of the orifaces in the float chambers the same? The other 2 carbs have .54d stamped on them.