choke solenoid for 1974 chrysler outboard model 707hf

C

christo555

Seaman Apprentice
Joined
Aug 12, 2010
Messages
49
hi,
anybody have a source for a new/used choke solenoid for my engine? chrysler 707hf 70hp mine pulls in fine but doesn't release. it gets jammed in its pulled in position.
thank you, christo555
 
fucawi

fucawi

Banned
Joined
May 18, 2011
Messages
1,039
Re: choke solenoid for 1974 chrysler outboard model 707hf

I have seen them on e bay but on myown I used a door lock actuator about $10
 
jerryjerry05

jerryjerry05

Supreme Mariner
Joined
May 7, 2008
Messages
17,926
Re: choke solenoid for 1974 chrysler outboard model 707hf

Before you buy. Clean it out with WD-40 and compressed air.Then clean it again.
Then you can adjust them.
I might have an old one.
Post a pic of it next to a ruler.I think they are all standard just wanna make sure??

Door lock actuator?? How about a pic??
 
fucawi

fucawi

Banned
Joined
May 18, 2011
Messages
1,039
Re: choke solenoid for 1974 chrysler outboard model 707hf

photos no problem...sure these motors are universal..you must get the 5 wire one as it has switches at each end of the travel.....normally a lock motor is pulsed with 10 x 0.5sec pulses as you cannot leave 12v connected to the stalled motor.........so at full choke the swictch opens and there is a 22ohm resistor ( or 10w 12v bulb) across the switch to provide a holding current ...
you may think the mounting unusual but just not enough space to put it in line ....
 

Attachments

  • AAAAA24 004.jpg
    AAAAA24 004.jpg
    140.3 KB · Views: 0
  • AAAAA24 003.jpg
    AAAAA24 003.jpg
    147.3 KB · Views: 0
zopperman

zopperman

Lieutenant Commander
Joined
Jun 22, 2011
Messages
1,551
Re: choke solenoid for 1974 chrysler outboard model 707hf

That's just awesome :eek:
 
C

christo555

Seaman Apprentice
Joined
Aug 12, 2010
Messages
49
Re: choke solenoid for 1974 chrysler outboard model 707hf

thanks for the help. i did try spraying the plunger with wd40 but while it was mounted. maybe that's why it didn't free up. i'll remove the plunger from the solenoid and try to lube and blow it out. and let's see what happens.
christo555
 
C

celtic gelf

Seaman
Joined
Aug 21, 2011
Messages
68
Re: choke solenoid for 1974 chrysler outboard model 707hf

show this door actuator lol I gotta see the... yes i have a parts guy....there's a fellow that bought every part in the mercury plant after they stopped making force.....for pennies on a dollar he's a gold mine
 
tater76

tater76

Senior Chief Petty Officer
Joined
May 7, 2010
Messages
712
Re: choke solenoid for 1974 chrysler outboard model 707hf

See my pm to you
 
You must log in or register to reply here.
Top