DIY Flywheel holders

R

restornator

Petty Officer 1st Class
Joined
Aug 15, 2009
Messages
361
I need a cheap flywheel holder the remove and install flywheels, i would need to be able to torque the crankshaft nut to 120 foot pounds. I could make an OMC flywheel holder that is illustrated in the service manual i have, but buying a metal hole cutting bit for $20, to be used only once, beats the purpose. Anyone have any ideas?
 
royal0014

royal0014

Master Chief Petty Officer
Joined
May 6, 2010
Messages
874
Re: DIY Flywheel holders

This subject has been visited before, maybe search the archives....

My suggestion is a ratchet/tie-down strap. Wrap around the f/w two or three turns, hooked to the engine's lifting ring. Worked like a charm.
 
You must log in or register to reply here.
Top