Trim up on shifter not working

L

Leedanger

Petty Officer 1st Class
Joined
May 29, 2011
Messages
323
I swapped out a gimbal housing from a post 78' to a pre-78', the one I just put on has a linear style trim sender and the broken one had the senders on the side of the gimbal housing by the hinge pin. Since the swap the "bow up" function doesn't work, the "trailer" button does and so does the "bow down".

Anybody? Cheers.
 
Bondo

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
70,524
Re: Trim up on shifter not working

Leedanger said:
I swapped out a gimbal housing from a post 78' to a pre-78', the one I just put on has a linear style trim sender and the broken one had the senders on the side of the gimbal housing by the hinge pin. Since the swap the "bow up" function doesn't work, the "trailer" button does and so does the "bow down".

Anybody? Cheers.
Click to expand...

Ayuh,.... Ya didn't wire the "bow up" circuit through the limit switch...

Ya can wire it direct, but it won't stop at Trim, 'n will go to Tilt instead...
 
You must log in or register to reply here.
Top