which quicksilver control do I have?

looking in my service manual I honestly cant tell if its a commander or commander 2000 setup.

I have power tilt/trim, electric start, and a warning horn (disabled as it was screaming at me...yes I'll fix it later lol).

anyway, here's some pics, let me know if you need more to help me properly figure this out.

currently, the purple wire goes to the 12v on all the gauges (if I remember correctly)
the grey wire goes to the tach signal
the brown/white stripe goes to the tilt/trim gauge
the tan just loops back on itself into the harness as it always had
the black is just unhooked as I have no idea where it goes

the diagrams I have in my service manual say otherwise but when I traced the wires to the engine they went elsewhere so I hooked them up accordingly. I just have no idea to be honest, help me please

if you need more info/pics please let me know, I'll get whatever info I need to get the gauges fully functional.

Re: which quicksilver control do I have?

Did you ever get a reply on which quicksilver control you have. I have the same and lost as to how to connect to the motor. Also what is at the top of the first picture, side view? Is it the choke or Kill switch? I am looking for the manual or something to show me what these wires are to go to.

Re: which quicksilver control do I have?

I just got a controller exactly like the one above. Where does the tan wire go in the second picture?