Audio alarm sounding constantly on a Mercury I/O...

lkgraleigh said:

Hi,

I have a 2006 Bayliner 197 deck boat with a Mercury 190 HP I/O engine. Normally, when I start it there is a loud alarm that goes off and when it starts, the alarm stops. The alarm is constantly going off (really loud!!). The manual says it is either low oil pressure, low gear lube or hi temp. The oil pressure if good and oil level is good (pressure on guage), the gear lube was just changed (pumped from bottom hole to make sure there was no air in it) and the temp is fine (the gage is low and it does come up a bit, but just to normal operating temp, so I know the gage is working).

I was wondering if there is a switch that controls this alarm and if so, where it is? Any help would be greatly appreciated.

Thanks,

Mark

Click to expand...

lkgraleigh said:

Thanks, do you know where the sensors are? There is another thread that talks about normally open switches and one will prob be closed (or 0 resistence), but I do not know where the switches are?

Thanks... Mark

Click to expand...