1995 Mercury 115hp Carb fuel inlet valve

A

amenges0903

Recruit
Joined
Mar 12, 2011
Messages
1
Well, I was cleaning my carbs and accidentally dropped one. Long story short the 90 degree elbow where the fuel line connects, broke off on the top part of the carburetor. I'm pretty sure it's made out of aluminum, and it's not a threaded attachment. I was wondering if it's possible to drill out the part that broke off, and if they even sell that fuel inlet valve???????? Or if i'd have to grit my teeth and buy a new carb?
 
1

1nebel0

Chief Petty Officer
Joined
Nov 28, 2005
Messages
512
Re: 1995 Mercury 115hp Carb fuel inlet valve

Ebay....people are always blowing up motors and parting them out..look at the number on your carb...You will need to buy the right carb or probably just pick up the set...make sure it is the same series as what you have....Carbs if available can cost $350 for each one depending on the model and carb...good luck
 
You must log in or register to reply here.
Top