3.0 engine mount

B

bobhol

Petty Officer 2nd Class
Joined
Oct 5, 2009
Messages
146
I am attempting an alignment and all my wrenches stop at 1 inch ...what is the nut size to adjust the front mounts..it is tight for my adjustable and I dont want to round out the nut edges.My readings in the grease were deep grooves on the top of the bar ...so ..I am lowering the front of the motor..right? thanks,Bob:confused:
 
Bifflefan

Bifflefan

Commander
Joined
May 27, 2009
Messages
2,933
Re: 3.0 engine mount

The nut is 1 1/8th.

Why does everyone go the wrong way?????
No,
Heavy marks on top and none/slight on bottom means go up on the front. Always go towards the heaviest marks, until they get equal.
The rear mounts are behind the coupler so that makes the pivot point behind the coupler.
 
Alpheus

Alpheus

Lieutenant Commander
Joined
Aug 3, 2009
Messages
1,757
B

bobhol

Petty Officer 2nd Class
Joined
Oct 5, 2009
Messages
146
Re: 3.0 engine mount

Thanks for the wrench size...I don,t feel so bad about being confused now !!! Bob:):)
 
You must log in or register to reply here.
Top