1996 75hp force exhaust gasket replacememt

C

caution

Cadet
Joined
Oct 21, 2008
Messages
15
Found some unburnt exhaust leaking at the bottom of the port side exhaust plate. Wondering if this is a dificult job to replace the gaskets. Should I use locktite of any kind? Anything I should watch out for before I begin? Any help with this would be appreciated.
 
jerryjerry05

jerryjerry05

Supreme Mariner
Joined
May 7, 2008
Messages
17,926
Re: 1996 75hp force exhaust gasket replacememt

See if you can tighten the bolts holding it in.
Some times changing these gaskets can be rough.A lot of times they will leak worse.
Make sure the mating surfaces are SPOTLESS!!! Use some kind of gasket sealer.OMC/Merc puts out a good sealer.Don't overdo it with the sealer a thin coat will work .J
 
You must log in or register to reply here.
Top