Transom cap/rail rivets

S

ski1559

Seaman Apprentice
Joined
May 14, 2010
Messages
48
I have a 14ft starcraft seafarer. On my transom there is an aluminum cap that is approx. 1.5 inches wide and runs the width of transom. Along this cap there are rivets the go through this cap. These seem like a very long thin rivet.
How do I tighten them up? Take them out?
Replace them?
What type is this rivet if it is a rivet at all?




Somebody help me, I'm clueless...

ski
 
CBGale2

CBGale2

Lieutenant Junior Grade
Joined
Apr 22, 2009
Messages
1,026
Re: Transom cap/rail rivets

Should just be a nail with a twisted shaft. Pull em out or hammer em in.
 
P

Pugetsound

Lieutenant Commander
Joined
Apr 5, 2009
Messages
1,824
Re: Transom cap/rail rivets

The same kind of nail ( SPIRIL NAILS) these are also used on the frame to the dash panels. They work great on plywood as they screw themselfs in to the wood (no pun intended ) .
 
S

ski1559

Seaman Apprentice
Joined
May 14, 2010
Messages
48
Re: Transom cap/rail rivets

Awesome. Seems easy enough. I think I'll just tap them in a bit.

ski
 
P

Pugetsound

Lieutenant Commander
Joined
Apr 5, 2009
Messages
1,824
Re: Transom cap/rail rivets

yOU MIGHT PULL THEM OUT ONE AT A TIME AND INSERT A STICK MATCH IN THE HOLE. THEN REINSTALL THEM THEY WILL HOLD FOREVER THEN
 
You must log in or register to reply here.
Top