Johnson PTT motor internal wiring?

W

wbw189

Recruit
Joined
Aug 11, 2005
Messages
5
I have a Johnson 60ESL70 with a three wire power tilt and trim. When I tried to use the PTT this year it would not function. I had the unit rebuilt in 2007. I finally pulled the EFT 4003 motor this past weekend to find it half full of water. I cleaned the housing to find two wires broken off the brush holder. I cannot figure out which point to solder these wires on. Has someone here done a similar repair? Anyone have similar unit with pictures?

Thanks, Ben
 
M

Miroash

Banned
Joined
Jul 15, 2009
Messages
126
Re: Johnson PTT motor internal wiring?

I dont know the answer, but I'd be willing to bet you could get a quick answer with a photo so someone who does know will know exactly what your reffering to.
 
W

wbw189

Recruit
Joined
Aug 11, 2005
Messages
5
Re: Johnson PTT motor internal wiring?

Good Call, Miroash. I will have time tomorrow evening to take a picture and post. Are there any other schematics available than those found on the BRP website? Thanks, Ben
 
You must log in or register to reply here.
Top