Richard Kagen
Recruit
- Joined
- Jul 8, 2009
- Messages
- 2
Hello All-
New here to this forum.
Not sure of the exact year of this motor, but it pull started (non electric) ran well 2 years ago. Last year it had a broken plastic fuel pump housing which I ordered and installed.
While working on it I noticed that the wire connectors on the right side of the engine were rotted out. I replaced the connectors (appear to be the kill switch line) and I am questioning if I mixed them up as the motor is dead as a doornail. Anyone have the diagram or able to explain how these 3 wires should be connected?
New here to this forum.
Not sure of the exact year of this motor, but it pull started (non electric) ran well 2 years ago. Last year it had a broken plastic fuel pump housing which I ordered and installed.
While working on it I noticed that the wire connectors on the right side of the engine were rotted out. I replaced the connectors (appear to be the kill switch line) and I am questioning if I mixed them up as the motor is dead as a doornail. Anyone have the diagram or able to explain how these 3 wires should be connected?