DonutEatingCop
Recruit
- Joined
- Jun 11, 2009
- Messages
- 1
Hi,
I recently purchased my first boat with this motor. I replaced the impeller, but when I went to put the lower unit back on, I noticed that the end of the shift rod was bent and the lower unit wouldn't go back on. Is this a normal thing, and if so, any suggestions on how to get the lower unit to mate up?
Thanks, any info would be helpful
I recently purchased my first boat with this motor. I replaced the impeller, but when I went to put the lower unit back on, I noticed that the end of the shift rod was bent and the lower unit wouldn't go back on. Is this a normal thing, and if so, any suggestions on how to get the lower unit to mate up?
Thanks, any info would be helpful