Hello,
I have recently rebuilt a 1998 evinrude 3.3 hp after it was overheated by the previous owner, although fotunately without damage to the cylinder or piston. However, in the lower RMP range, i.e. below half throttle, it is runs very lumpy. Is this due to the lack of ignition retardation, or is there a fuel problem?
I have been running the outboard on a 50:1 mixture, although I believe the outboard may in fact run on a 100:1 mixture. Could any one verify this please?
Also if anyone has a copy of the owner's manual, that would be creately appreciated.
Many thanks.
I have recently rebuilt a 1998 evinrude 3.3 hp after it was overheated by the previous owner, although fotunately without damage to the cylinder or piston. However, in the lower RMP range, i.e. below half throttle, it is runs very lumpy. Is this due to the lack of ignition retardation, or is there a fuel problem?
I have been running the outboard on a 50:1 mixture, although I believe the outboard may in fact run on a 100:1 mixture. Could any one verify this please?
Also if anyone has a copy of the owner's manual, that would be creately appreciated.
Many thanks.