phwrd
Petty Officer 1st Class
- Joined
- Jul 30, 2007
- Messages
- 294
Since I replaced my gas gauge, guess i better replace the sending unit. At half full, gauge now reads 1/8 to 1/4.
Opps, gotta measure the depth of the tank. Removed the 5 screws and pulled the old sending unit out just enough to ran a ruler down the edge. 11 inches deep.
And sure enough, one of the screws went in with it. Tank is aluminum.
Gee, if the boat is manufactured right, should be a (non-metallic) stainless screw, so a magnet isn't going to work. Might have to go with a small tropical fish net with a long handle.
Any one else have any Ideas or Comments (beyond me being an idiot) ?
Thanks.
Opps, gotta measure the depth of the tank. Removed the 5 screws and pulled the old sending unit out just enough to ran a ruler down the edge. 11 inches deep.
And sure enough, one of the screws went in with it. Tank is aluminum.
Gee, if the boat is manufactured right, should be a (non-metallic) stainless screw, so a magnet isn't going to work. Might have to go with a small tropical fish net with a long handle.
Any one else have any Ideas or Comments (beyond me being an idiot) ?
Thanks.