[bbrown0921]

We have a 1995 225 Evinrude and we are on our third lower unit that has trouble going into reverse. I finally looked at the linkage and have decided that the Morse controls don't have enough travel for this engine. We use 3300 cables and dual lever Morse controls. When I unhook the cabes and shift by hand there is about 1/2 inch more travel than the Morse controls give in normal operation. If I adjust the linkage to go into reverse then it doesn't go into forward!

Can any one confirm or advise me on what to do?

[Faztbullet]

Make sure shift rod height is set correctly. Also check # 97 in attached diagram, as I have seen the weld broken on these and it will cause extra play in shifting as you describe.