Mariner 15hp 1980s FUEL CONNECTOR

M

MARK BRAY

Cadet
Joined
Nov 16, 2007
Messages
15
I Need 3 Point Connector From Fuel Line To Engine.any Ideas Where To Get One From Or Should I Make New One Up?
 
B

bgbass.1

Chief Petty Officer
Joined
Aug 1, 2007
Messages
558
Re: Mariner 15hp 1980s FUEL CONNECTOR

you can get them at napa walmart here at iboats
 
M

MARK BRAY

Cadet
Joined
Nov 16, 2007
Messages
15
Re: Mariner 15hp 1980s FUEL CONNECTOR

Many thanks for reply. found out today that engine is 1970s and originally the third pin was for kerosine even now though its a blank.is it still the same fitting you mentioned.
 
B

bgbass.1

Chief Petty Officer
Joined
Aug 1, 2007
Messages
558
Re: Mariner 15hp 1980s FUEL CONNECTOR

you can eliminate the third one and run 2
 
M

MARK BRAY

Cadet
Joined
Nov 16, 2007
Messages
15
Re: Mariner 15hp 1970s FUEL CONNECTOR ?

Re: Mariner 15hp 1970s FUEL CONNECTOR ?

Thanks again .I have tried a standard connector but the actual fuel spiggot coming out of engine is larger 9/32 and aligning spiggot is7/32 .Distance between centres on spiggots is9/16 .The model number is 651s001978 .tried searching on web but to no avail has this been superceded by another number? Hope not to waste too much of youir time ,thanks again
 
B

bgbass.1

Chief Petty Officer
Joined
Aug 1, 2007
Messages
558
Re: Mariner 15hp 1980s FUEL CONNECTOR

look at this site www.ishopmarine.com click on parts list click on mariner click on 15a and click on model number on left side click on gas tank # 33 is end see if it looks like yours
 
M

MARK BRAY

Cadet
Joined
Nov 16, 2007
Messages
15
Re: Mariner 15hp 1980s FUEL CONNECTOR

:)Thanks once again,the connector is still available but its over $50 at least youve pointed me in the right direction for spares and info.Had a look at the cowling assembly and it shows the spiggots unscrewed .so will try removing them and replace with modern fittings .Regards Mark UK.
 
You must log in or register to reply here.
Top