[Benny1963]

have looked on brp but there numbers wont cross to sierra
have tried i boats and ishop marine would like rebuild kit but will take new seliniod its leaking from slec shaft and probaly diafram motor has been a little rich at idle this is a pre mix motor any help finding these parts would help. or what catalog heading will help .
thanks benny 1963

[tashasdaddy]

i just both a complete soleniod on ebay.

[OBJ]

Parts for primer solenoids are like "captured parts". Only place to get them is through a Bomby (J/Rude) dealer.

[Benny1963]

thanks iguess you have to call jrude and buy parts seperatly
i wonder if they sell a rebuid kit or if its wort the effort
am going on ebay to look because i saw them on there to
but figured that i could get sierra from napa

[OBJ]

Benny...what parts do you need? Not a whole lot in these solenoids to go bad other than the front cover.

[Benny1963]

hey i need cover gasket and whatever seals selec arm
when i pumped up my ball gas came out the arm area but it seems to be leaking fuel to cyls
dont know how to test for the lines to see if they are leaking into cyls intake not sure were they lead
thanks very much benny 1963

[OBJ]

Here's what to get Ben....

Cover and gasket kit....PN437228
Maint Valve......PN175158

Both together will cost under $20 and should take care of your problem.

[tashasdaddy]

to test is it is leaking into the motor, remove the small hose, on the back part of the carb, pump the bulb. if you get gas out of them the valve is leaking.

[moterboat]

I would check for a used one at some omc repair shops,I purchased a used one 2 weeks ago for my 140 for $30.00 installed...

[Benny1963]

hey thanks for the part numb.,.ers and advice will rebuild .
thanks .
benny 1963