[JDP]

OK after the last time I took the boat out after getting it running, I installed some dol-fins to help get on plane faster. It does get on plane faster but I noticed that it leans to left. I thought briefly that it because of my wife sitting over on that side (shh don't tell her I said that) But then I realized that after slowing down the boat levels back out. I am very picky about my measurments and I'm positive that both sides are even. Is it possible that I got a set that one side is warped? I have looked really close at both of them and seem to be exactly the same. Any advice on this issue??

[MikDee]

Chances are, the Doel fin is holding it there when on plane, the only way to avoid that is to raise the motor so that the Doel fin is ontop of the water when planing,,, I think,,,lol