[ASCTLC]

Can the aluminum prop be vented safely such as is common with stainless props? Seems I never see "vented" and "aluminum" in the same posts.

Planning on going to an aluminum 4-blade and would like to know if this is possible if my hole-shot needs a slight improvement.

Thanks,
Andy

[tommays]

It works BUT the lack of cup in a plain ALU prop has a very limited trim range once the holes are drilled compared to the same prop without vents

5/16 IS A BIG HOLE DRILL CAREFULL

It is in 5/8 from the edge and you have to eyeball inside the prop to be sure your not drilling into the web to the HUB

Tommays

[180shabah]

For drilling your own, follow Tom's advice.

For others who may be interested, the Turning Point Hustler is a vented Al prop. It not quite as good as an SS, but the improvement over the "Black Max" that came on m boat was amazing, especially when you through price into the mix.