Dublin Bren
Recruit
- Joined
- May 28, 2007
- Messages
- 3
Hi All.
I am a newbie here so please go easy on me.
Here is my problem. I am trying to adjust my shift linkage after replacing my Gimbel bearing but when i look on Stuart hastings page the pictures are not very clear in picture 82. It says move shift cable guide in or out until lower vertical edge of guide tab is flush with pivot housing gasket surface. WHAT IS THE LOWER VERTICAL EDGE. Is it the back of the first thick piece about 1" in from where the swivel retainer touches, or is it the the thin tab that sticks down and points towards the swivel retainer about 21/2" back. Any help or a clear picture would be great.
Thanks. Bren.
I am a newbie here so please go easy on me.
Here is my problem. I am trying to adjust my shift linkage after replacing my Gimbel bearing but when i look on Stuart hastings page the pictures are not very clear in picture 82. It says move shift cable guide in or out until lower vertical edge of guide tab is flush with pivot housing gasket surface. WHAT IS THE LOWER VERTICAL EDGE. Is it the back of the first thick piece about 1" in from where the swivel retainer touches, or is it the the thin tab that sticks down and points towards the swivel retainer about 21/2" back. Any help or a clear picture would be great.
Thanks. Bren.