HELP WITH WIRE SIZE FROM BAT TO TRIM S

Benny1963

Benny1963

Lieutenant
Joined
Sep 17, 2006
Messages
1,476
HAVE TWO WIRES THAT RUN FROM BAT TO TRIM S

AWS WHANTING TO KNOW WHAT SIZE WIRE TO USE
AND SHOULD IT BE FUZED BEFORE OR AFTER SELINOID THANKS STILL LEARNING TO POST AND TYPE

THANKS A LOT BENNY 1963
 
OBJ

OBJ

Supreme Mariner
Joined
Dec 27, 2002
Messages
10,161
Re: HELP WITH WIRE SIZE FROM BAT TO TRIM S

Benny...first....take the cap lock off. The large type is hard to follow.

A year and horse power will also help. If not sure of the year, post the model number. That'll tell us the year and hp.

Battery leads to the TNT unit are usually either #6 or #8 stranded wire.....depending on engine size.
 
Benny1963

Benny1963

Lieutenant
Joined
Sep 17, 2006
Messages
1,476
Re: HELP WITH WIRE SIZE FROM BAT TO TRIM S

sorry about that
engine is 1981 evinrude 150 crossflow

thanksbenny1963
 
Benny1963

Benny1963

Lieutenant
Joined
Sep 17, 2006
Messages
1,476
help tach prboblem

help tach prboblem

evinrude 150 crossflow 1981 tach is 1000 rpm off
was working fine was told by tech could be rectifyer
or tach and that rectifyer was water cooled and expensive can you check rec with common volt meter
thanks everyone

benny 1963
 
You must log in or register to reply here.
Top