[HarleyXL]

I'm going to replace the exhaust gasket, but have problems removing the powerhead. I "think" that I only have one nut left to remove, but I'm not sure. This nut is paced on the left side (seen from behind) on the powerhead, but there is no way of getting to it, at least without a very, very special tool. My guess is that I have missed something.

I think I'll be able to get to the nut if I was able to remove the lower engine cover, but that seems to be impossible without first removing the powerhead.

I have a Seloc manual (1.75 - 70 HP), but there is no discription on how to remove the powerhead or the lower engine cover.

Any ideas?

[muskrat]

yes it is a special tool,try a distr wrench it should be bent a niff.