Mariner 1996 25HP tiller model won't go in reverse

rdlyon · #1 February 27th, 2007, 01:42 PM

We had a new impeller installed at Paris Marine. After install the motor won't go into reverse unless you push the tiller hard to the left (tiller and cable side of engine) then it will go into reverse until you straighten the moror gain and go forward. Mechanic says it is a flaw in this engine. I don't think the lower unit was put back properly. Any ideas?

rdlyon · #2 February 27th, 2007, 01:44 PM

Quote:

Originally Posted by rdlyon

We had a new impeller installed at Paris Marine. After install the motor won't go into reverse unless you push the tiller hard to the left (tiller and cable side of engine) then it will go into reverse until you straighten the motor again and go forward. Mechanic says it is a flaw in this engine. I don't think the lower unit was put back properly. Any ideas?

Don S · #3 February 27th, 2007, 02:49 PM

It's not a flaw in the engine, it's a flaw in your mechanic. It's not adjusted properly if he took it apart wrong. Or he lost the washer or put it in the wrong place on the shift linkage.
Might want to have a look and verify washer is located like this.