Tilt Trim Fluid replacement on 1990 gt 200

D

Drva50

Recruit
Joined
Oct 3, 2006
Messages
3
I had a o-ring seal go bad and lost fliud in the tilt trim and it will not lift up or go down. Motor and pump are working I just need to add fluid and bleed. This is a 1990 Johnson Gt 200. Just need to know where to add and bleed the fluid, any help would be great.
 
D

DJ

Guest
Re: Tilt Trim Fluid replacement on 1990 gt 200

You should see a large head (slotted) screw on the pump/reservoir assembly. THat is the fill hole. The system bleeds itself while you cycle it up and down.
 
M

mikesea

Lieutenant Commander
Joined
Oct 1, 2006
Messages
1,830
Re: Tilt Trim Fluid replacement on 1990 gt 200

fill it to it drips out the hole.run it up and down,fill again,do this until it wont take any more fluid
 
D

Drva50

Recruit
Joined
Oct 3, 2006
Messages
3
Re: Tilt Trim Fluid replacement on 1990 gt 200

DWJ said:
You should see a large head (slotted) screw on the pump/reservoir assembly. THat is the fill hole. The system bleeds itself while you cycle it up and down.
Click to expand...
 
D

Drva50

Recruit
Joined
Oct 3, 2006
Messages
3
Re: Tilt Trim Fluid replacement on 1990 gt 200

Thanks I will fill it tomorrow just need a bigger flat head so I dont damage the screw.
 
You must log in or register to reply here.
Top