[imported_DANN]

the trim motor sounds and run good but hydranlic fluid is leaking somewhere . a friend told me I might need to replace to the seals and gaskets on the trim motor .has anyone ever done this work on there outboard?

[Ray Neudecker]

Close observation should make it easy to identify the source of the leak. Then helpful suggestions would be possible.

[imported_DANN]

mr ray the unit is in need of new o.rings seals ,gaskets sorry it took so long to get back to you. been very busy . I got a new post on this matter. any advice would be very helpful. Dann

[badlar]

Had one of mine rebuilt at a local hydraulic shop. Far less expensive than the marina. Works fine. HOPE THIS HELPS.

[imported_DANN]

badlar what was the name of the place you had it done at? if you still can remember it would to helpful, maybe i can ship it to them to fix it if the $$ is right

[badlar]

This is where I had mine rebuilt. You would probably be better off finding a hydraulic shop in your area.

Gibson Hydraulics, Inc.
16209 N. Florida Ave.
Lutz, FL 33549
Phone: 813-961-3504
Fax: 813-962-8364