How do I remove pick-up tube on existing aerator?

K

kompressor

Recruit
Joined
Apr 8, 2006
Messages
2
My aerator pump is completely frozen. I'm replacing it with a new unit. They are both thru-hull models, Attwood A500's. I tried removing the existing pick-up tube, but the nut is plastic and was installed with marine sealant/adhesive. The nut keeps rounding on the corners and is being chewed up. I've tried a crescent wrench and a 1.5inch socket. Any suggestions removing this pick-up tube? Thanks.
 
T

TD_Maker

Chief Petty Officer
Joined
Aug 31, 2005
Messages
564
Re: How do I remove pick-up tube on existing aerator?

Try cutting it off with a Dremel Tool. Worked for me.
 
Boatist

Boatist

Rear Admiral
Joined
Apr 22, 2002
Messages
4,552
Re: How do I remove pick-up tube on existing aerator?

Try a pipe wrench or as TD said. Could also drill out the center. Once you get it out clean up the hole and install the new one with some good sealer.
 
K

kompressor

Recruit
Joined
Apr 8, 2006
Messages
2
Re: How do I remove pick-up tube on existing aerator?

Thanks for the help. The Dremel did it. Cut a notch out of the nut, then used a flathead and a hammer to break the seal and drive the nut off.
 
You must log in or register to reply here.
Top