DT65 Choke....how does it activate?

B

betzar

Recruit
Joined
Jul 5, 2005
Messages
4
The choke is controlled by an electric solenoid, but I don't know what activates the solenoid? There is no choke on my controls that I can tell. Is the choke activated automatically when the ignition it switched on? The motor won't start the firwt time without starter fluid..then it starts very easily the rest of the day.
 
L

Lasse Lehtonen

Seaman Apprentice
Joined
Jun 29, 2005
Messages
46
Re: DT65 Choke....how does it activate?

choke is used by pushing startingkey inside when starting engine. choke solenoid works when you have turned power on and when you are starting.So when you start your motor cold turn the startingkey normally to start the engine and at the same time push it towards your controller.If it does not start check that the solenoid is working (take off the eng cover so you can see carb/s and when startkey power on/or starting push the key inside, then the linkage to the carb/s should move.
 
B

bossee

Senior Chief Petty Officer
Joined
Jul 18, 2002
Messages
727
Re: DT65 Choke....how does it activate?

Push the starting key in direction of arrow that is shown in picture below.<br /><br />
Su_NA12S.jpg
 
B

betzar

Recruit
Joined
Jul 5, 2005
Messages
4
Re: DT65 Choke....how does it activate?

Thank you sir. That was exactly what I was looking for.
 
You must log in or register to reply here.
Top